SX/SXi/SXi Pro What to do with the oil injection lines?

[Bmedlin85]

I am planning on running premix this season and doing away with the oil injector on my 95 750SXi. Now, what should I do with the injector lines that run into the carbs... plug and leave the lines, remove the lines and plug the holes??? I had a seadoo 580 years ago that I just plugged the lines on and it did fine but I would rather do away with them all together. Any thoughts?

 

[Snivilous]

Remove the lines, then cap the ends where they hooked up to. Or you can plug them, though would just be harder to undo if you ever wanted to.

 

[Bmedlin85]

Cap the ends with what?

 

[baxt3r]

Caps?

 

[IS0LD0UT]

Most of the kits provide 2 little caps. I know jet maniacs do, but this was for a yamaha.

 

[Bmedlin85]

So that is what those 2 "caps" are in every oil blockoff picture... Awesome!!! Thanks

 

[garretonufer]

yami's bolt to the fly wheel cover, you can pull that out and put a block off plate there.

kawis... no idea.

 

[Bmedlin85]

yami's bolt to the fly wheel cover, you can pull that out and put a block off plate there.

kawis... no idea.

Yeah the Kawi's bolt to that cover also. I was referring to capping the oil injection ports on the carbs.

 

[baxt3r]

Seems like a good kit will come with everything you need. I remember the blockoff kit for my old GP1200 came with plate, gasket, and caps. But, it's not a Kawi.

 

[nightrider05]

Go to your local auto store and pick up some vacuum caps. They are usually long enough to allow the use of a small zip tie on them and come in all different sizes.