Super Jet What size / thread is handle pole pivot bolt?

S

segmentlime

Location
near beautiful bobcaygeon
I am changing what I think is a stock handle pole on a 96 SJ700 for an RRP cast aluminum pole.

The pivot point fasteners in use were as shown in the picture.

IMG_1759.JPG

I knew I did not have a spring and bought a new one in preparation for the new handle pole installation; however, my fail, it was not until removing the old pole that I saw the existing pivot bushing fasteners
(and the penny dropped as to why no existing spring), and realized I will be needing a pivot bolt too.

What is the proper bolt size / thread for a superjet pivot bolt?
 
Last edited:
S

segmentlime

Location
near beautiful bobcaygeon
Thanks for the reply.

Those things I pulled out of the SJ700 were pretty messed up and so it was hard to tell what they were with a gauge, but likely imperial. After posting I felt more stupid to realize that I could just measure the bolt from my 4-stroke superjet, and this one is definitely M14 but I think the thread pitch is 2.0. The length seems to be 215mm.
 
Last edited:
You must log in or register to reply here.
Top Bottom