- Location
- LaPorte, IN
Hello all....I am new here, been lurking a bit and its time to post.
I recently picked up a 92 sn with a 95 701 installed.
Included in the deal was a westcoast head with removable domes. Same head referenced here: http://www.pwctoday.com/showthread.php?t=12337.
So does this just have o-rings in groove at small diameter,(close to plug), or are there supposed to be some around large diameter also?(behind dome?). Also where do I get the proper o-rings? And what type head gasket do I need? Compression is 135/135 now so I hope this will raise it a bit.
Thanks for the help in advance.
I recently picked up a 92 sn with a 95 701 installed.
Included in the deal was a westcoast head with removable domes. Same head referenced here: http://www.pwctoday.com/showthread.php?t=12337.
So does this just have o-rings in groove at small diameter,(close to plug), or are there supposed to be some around large diameter also?(behind dome?). Also where do I get the proper o-rings? And what type head gasket do I need? Compression is 135/135 now so I hope this will raise it a bit.
Thanks for the help in advance.
