650/X-2 West coast head o-rings

[Stefanko135]

Just picked up a west coast head ep7500 with 29cc domes. The o-rings are not looking to good and would like to replace them just how?? And what head gasket do you use?? the stock one goes over the o-rings when u place it on the head not sure if it should like that

 

[Stefanko135]

Bump anything on how to replace the dome o rings?!

 

[TontoM3]

Look on eBay, or just bring it to your hardware store and start checking for a size that will fit.

 

[Stefanko135]

I found the gaskets just how do i take out the domes?

 

[TontoM3]

Put in a spark plug, an old one and tap them out with a mallet. Use some penetrating oil.

 

[Stefanko135]

Any special way to put the domes back in or just push them back in?

 

[TontoM3]

just make sure they are in all the way! only one way to put them in

 

[swanson180x2]

I was able to find a whole west coast kit for mine on ebay. if you find O-rings make sure they are high temp. places like granger should have some. and as far as head gasket goes the only one you can really use in the westcoast one. do not use the stock kawi one or any other made for stock head. the westcoast steel shim gasket is reusable. http://www.ebay.com/itm/Kawasaki-Je..._Watercraft_Parts&hash=item5af615e609&vxp=mtr

 

[WB1994]

I was able to find a whole west coast kit for mine on ebay. if you find O-rings make sure they are high temp. places like granger should have some. and as far as head gasket goes the only one you can really use in the westcoast one. do not use the stock kawi one or any other made for stock head. the westcoast steel shim gasket is reusable. http://www.ebay.com/itm/Kawasaki-Je..._Watercraft_Parts&hash=item5af615e609&vxp=mtr

The stock 650 gasket works fine .......