Wanting to get more low end out of my 97 750sxi
- Thread starter Cody
- Start date
Magyar68
Really!!!
- Location
- Lewisville
measure the exit nozzle, if it is smaller than 80mm replace it. 92-94sx models used an 80mm nozzle and are a direct replacement.
- Location
- Dallas, GA
Also a 9/17 prop would help.
Sent from my iPad using Tapatalk
Sent from my iPad using Tapatalk
N3vrSat1sfied
Military Member
- Location
- Fort Worth, TX
Factory Pipe will be the hands down best mod for the ski, but on the upper end of the spectrum. I would start with a prop like Veedubs said. 9/17 or even a 8/16 if you are going to do other supporting mods.
- Location
- galveston
not to hijack but what about the R&D timing advance kit for around $45.00? does that work?
- Location
- Arnold MO.
Yes, they work. I noticed a small gain. Pretty relative to the cost. Noticed much bigger gains with a $500 exhaust. Stubby cone and big hub 9/17 with a bored nozzle or 650sx nozzle is about as far as you can go on a limited budget. Then your looking at bigger stuff like a FP pipe, flywheel, porting, ect...
Magyar68
Really!!!
- Location
- Lewisville
The 9/17 BigHub is important to note. I believe the 97 SXi from the Original Post has a 9/17 (Not BigHub) OEM Stainless. the Nozzle and Pump Cone cost me $50 total, with no Modification of anything, Just remove, replace and Ride.
The big hub will make better low speed thrust along with a larger nozzle. I would NOT install the advance plate it you ever ride full throttle for more than a few seconds.