- Location
- Sacramento, CA
I was wondering how many volts I should be reading from the spark plug wire on a 300sx, 550, and 650?
Thanks,
Jordan
Thanks,
Jordan
Last edited:
Other Volt question!
- Thread starter JETSKIHORDER18
- Start date
OCD Solutions
Original, Clean and Dependable Solutions
- Location
- Rentz, GA
please tell me you are using a high voltage reader and not a standard voltmeter...the voltage should be well above 10,000VDC.
Last edited:
Lucaumpits
RIDE LIKE U'VE STOLE IT!!
- Location
- Orlando, FL
- Location
- Sacramento, CA
hahaha im at that point where id like to shock myself, this damn ski wont work!!
OCD Solutions
Original, Clean and Dependable Solutions
- Location
- Rentz, GA
Post up your symptoms and what you've tried already and maybe we can help. There's a couple guys on here who know a thing or two about skis. :fing02:
- Location
- Sacramento, CA
Checkmy other post. Has no visible spark, changed the coil, still no spark, then randomly there is spark. Starts and runs and I tried it several times and it was good. Went and ate lunch, came back down and no spark????
DAG
Yes, my balls tickled from that landing
- Location
- Charlotte, NC
check the resistance through your ignition cables to make sure they arnt broke
SJBrit
Extraordinary Alien
- Location
- Bradenton, FL
Cables will definitely cause those symptoms. Try pulling the plug caps off and tug at a few of the strands in the cable - I bet some pull right out. If so then chop back until you get to good wire (if you have enough slack).