Tunnel porting 750sx cases
- Thread starter Crab
- Start date
- Location
- Grosse Ile
My cases were done and it seemed to help quite a bit, I'm not sure on all that was done though. I trusted Khan at Funk Motorsports to handle it for me and I love the results.
I have the sx cases and cylinder. I was told the SX cylinder was the best for the low end and that combined with the stroker and casework seem really strong compared to my other 750 with similar mods and porting. The cases were not done on the other boat.
I have the sx cases and cylinder. I was told the SX cylinder was the best for the low end and that combined with the stroker and casework seem really strong compared to my other 750 with similar mods and porting. The cases were not done on the other boat.
- Location
- Grosse Ile
My cases were done and it seemed to help quite a bit, I'm not sure on all that was done though. I trusted Khan at Funk Motorsports to handle it for me and I love the results.
I have the sx cases and cylinder. I was told the SX cylinder was the best for the low end and that combined with the stroker and casework seem really strong compared to my other 750 with similar mods and porting. The cases were not done on the other boat.
I have the sx cases and cylinder. I was told the SX cylinder was the best for the low end and that combined with the stroker and casework seem really strong compared to my other 750 with similar mods and porting. The cases were not done on the other boat.
- Location
- Grosse Ile
Sorry, I don't. I had the work done so I dropped it off and got back a shiny new running motor. When replacing the carbs you can see some of the work done in the intake area. No epoxy, but the left and right side of each intake tract is machined.
- Location
- The D
just esentially finger porting is what you're doing. I dont have any pictures, but it worked for my 750. Im not sure about the cases, mine were sxi pro cases, dont know if they're identical or not.