Trim Tilt Freestyle?

[Hydro3131]

How much HP do i need for a Trim tilt ? 30 degree

I mean when trim come to the right....60HP 80HP 120HP or more

 

[sjetrider]

????????????:sad6: not getting the question, someone help me out. :thinking:

 

[justride]

What?

 

[superjet0587]

id say as much hp as you can afford, but your question doesntr make sense

 

[Mark44]

No clue??????????????

Mark44

 

[#ZERO]

:hmmm:

We use handlebar mounted levers to operate the trim system. :thinking:

 

[superjet0587]

is he wondering hopw much power it takes backflip with 30 deg of trim?

 

[Big Kahuna]

A whole lot of power............... 120+ hp

 

[tor*p*do]

a 60 hp motor with hydraulic pump aught to do it!

 

[sjetrider]

A whole lot of power............... 120+ hp

But power is only part of the equasion right?
POWER 120 + BALLS 6" + boat set up $10000.00 =:brap:

Rough figures of course.

 

[FL-cracker]

Stock motor with 100 shot of nitrous... and a 80hp Trim motor with 43 degrees of tilt... and you should be able to nose one in no problem.

 

[sjetrider]

Stock motor with 100 shot of nitrous... and a 80hp Trim motor with 43 degrees of tilt... and you should be able to nose one in no problem.

But PLATE TO PLATE BF will require slightly more than 100 shot of NOS, you will however ba able to use the 30 deg. nosel w/ more NOS. IMO:brap:

 

[Big Kahuna]

Just add a MinnKota to the front of the ski for extra lift...... it is adjustible and foot controlled.

 

[DAG]

i can do a backflip off my pattle boat.. what are you guys talking about?

 

[Hydro3131]

I tried my friends 650 SJ 60HP...But the 30 degree trim tilt...isn't so much help...On flatwater....No backflips here

 

[Hydro3131]

How much HP do i need...for a backflip ?

 

[Hydro3131]

How much difference is it between 30 or 40 degree trimtilt ?

 

[Big Kahuna]

honestly to pull a flat water back flip you will need the following.

1. A very large engine, well over 800cc just go ahead and figure on about $4000.00-5500.00 for the motor alone.........

2. 49mm dual full spectrum carbs and manifold $2500.00

3. Lightweight hull $5000.00-10000.00

3. MSD Total Loss Ignition $1000.00 +

4. A real trim system $500.00

Figure $13,000.00 and that does not include the nuts and bolts...... or foothold, turf, handlepole, steering setup, pump and many other components.

 

[onlyFX-1]

Theres people out there bf with under 800cc. Its the same as people who are rolling on stockers, you have to have skill

 

[Big Kahuna]

Theres people out there bf with under 800cc. Its the same as people who are rolling on stockers, you have to have skill

Flat water back flips are more about power to weight ratio......... you use momentum to roll a mild to stock ski, but to pull a back flip you have to have huge amounts of power.