trim for 148/155 mag pumps what do you guys use

[masterblaster]

what type of trim are guys using for 148 mag pumps,looks like the ring bosses are about 6 mm wider than the 144 reduction nozzles on 144 pumps?

 

[ncbrock]

why dont you grind the ring?

EDIT: Nevermind, wasnt thinking. 6mm would probably make it too thin if the ring is even 6mm at all?

 

[masterblaster]

was thinking on grinding the ring and the bosses but wouldnt leave much room for the bolts to grab

 

[masterblaster]

ideas?

 

[superwetbrett]

pretty sure my 148 uses a reg 144 nozzle.. i am using the xmetal trim and it works great no mods so it has to be a stock 144 nozzle

 

[masterblaster]

dont see how that is possible,they are made from 155 pumps shimmed and have a 155 reduction nozzle,do you have the 1 piece billet 148 pump? what reduction nozzle do those use,I have a thrust trim system and the billet trim ring will not fit it,and I dont think he makes anything other than a 144 ring?

 

[Aircraftsalz]

I think me & Brett both have Billet Xscream mag pumps. My pump has a 144 reduction nozzle on it I'm positive. Purchased it from Chris, 62T nozzle.

Hope that helps.

 

[ATS_Aaron]

CATS based off the 97 (I think) Blaster 2 trim ring/nozzle?

Aaron

 

[masterblaster]

I see that the raider 1100 and blaster 2 both had 155 trim systems,guess that will have to do,gonna be a downgrade in angle from the thrust trim im using now. anyone have the trim ring and turn nozzle off one of these 155 pump skis

 

[masterblaster]

I assume you have to install this pump with no wear ring seal? anyone have experience with this?