tell me how to get this bolt

[AIRICCC]

the 8 that go through the crankcase and hold the halves together... i ordered them and they are on backorder until may 10, they may extend the backorder date, i want to make sure i have these before the riot ride, anyone know a part number for allstainless, or somewhere were i can get that specific bolt?

 

[njfl]

Not sure if you need all of them, which vary in size, but they are a 10mm grade 8 bolt. The combination of strengthening to grade 8 and protective coating (some form of zinc) make them quite resistant to corrosion. They aren't stainless. I don't know of a commonly available grade of stainless that can be produced to grade 8, so don't use stainless (unless it is clearly stated to be grade 8).

Factory pipe may have these. They ship them (or very similar ones) with exhausts to use for the three headpipe to manifold bolts.

 

[AIRICCC]

Factory pipe may have these. They ship them (or very similar ones) with exhausts to use for the three headpipe to manifold bolts.

if you are talking about the ones on a b pipe then we are thinking of different bolts... the ones im talking about are longer and narrow...

 

[njfl]

In the picture are a couple of the ones that I thought you meant. They are very shiny, like chrome and have an "8" on them. The thread size (not wrench size) is 10mm.

 

[AIRICCC]

no, not those... those i believe bolt the bedplates to the case... im talking about the 8 bolts that hold the case halves together

 

[romack991]

call paul (magoos), i had 4 ordered and cancelled it since you gave me your extras

 

[AIRICCC]

im going to need 8... theres a good chance zach has some extras in his misc. bolts box... ill check it out

 

[gj_fx1]

The combination of strengthening to grade 8 and protective coating (some form of zinc) make them quite resistant to corrosion.

Now all along I thought yamaha was saving a buck using plated instead of stainless...

 

[AIRICCC]

this is a very crucial piece in my quest for lanier.... does anyone have these?

 

[unclehulka13]

you cant get them in reg steel? I mean, you dont ride in salt water.

 

[Mark44]

Try www.mcmastercarr.com

Mark44

 

[AIRICCC]

I would check mcmaster but i dont know the specs on it... if anyone wants to find it for me on mcmaster I will send you a dollar through paypal (you can get a 10 minute phone call for under a buck!)

 

[AIRICCC]

its important, getting close to the riot ride... my crankcase is going to fly apart if i try to run it without those :afro:

 

[keefer]

As much as I hate to say it. Have you called SBT? Surely they have scads of bolts around with all the engines they rebuild. There has got to be plenty of junk Yami motors laying around with bolts a plenty. Also you might PM "tricky1" he has alot of goodies.

 

[gj_fx1]

61x case main case screws:
8mm 1.25 pitch 85mm long (only first 25mm threaded)

 

[AIRICCC]

thanks for the help guys, i didnt even think about sbt... ill keep them in mind for the future... i got a set from mike