Other T Handle Carb Adjustment Screws

[701FreeRide]

Hello All,

I am just installing my T Handle Carb adjustment screws on my 07 Superjet and when I pulled out the Low End it had the spring and O rings on it. I am assuming but wanted to be 100% sure that on the Low and High End screws both will have springs and O rings and you will swap them over to the T Handle Adjustment Screws and put them back in. Simple as that is my thoughts but correct me if I am wrong.

Thanks

 

[tor*p*do]

yup, swap over the oring and spring, good to go!

 

[dre23]

Yes u do..

 

[701FreeRide]

Thanks Everyone

 

[Tyler Zane]

you will love the t hadles. i know i do.

 

[swapmeet]

Where can I order these?

 

[Yami-Rider]

Blowsion sales them...: http://www.blowsion.com/products/36-mikuni-adjusting-screws.aspx

 

[FlightPlanDan]

Check the taper on the point against your stock needles. I got a set that made tuning a nightmare.

 

[2XLR8]

The taper angle is the same the only difference is the aftermarket ones aren't as pointy. As long as thread pitch is the same which you could not install them if it wasn't once you seat the screw and you back it out the area between the seat and the screw should be the same and thats what determines the fuel flow. I tuned a set of modified 38's with the T handles and I didn't noticed any tuning problems.

 

[FlightPlanDan]

Some are different. Not "all". Sorry if I wan not clear.