SXR timing advance plate

[IceRocket1286]

Do i have to pull the motor to instal a timing advance plate? I dont know if theres enough room between the tank and flywheel cover, and wanted to know. My sxr isnt home, so ive got nothing to look at. Bringin it home tomorrow

 

[justincr250]

timing

I did mine without having to pull the motor or tank. There is actually more Room there then you think. You'll see once you have your ski in front of you.

 

[IceRocket1286]

Ok, got the cover off. Now, how DO i get those wires out of the cover, or get the cover out so I can work on it? Also, do i have to grind the inside face of the cover? Ive heard that the plate sticks out further and hits the cover.

 

[Big Kahuna]

yes, you may have to grind some of the cover, if you go through it, just use some JB Weld to re-seal it........ she screws are a bitch...........

 

[IceRocket1286]

how do I get thoe cover out of my ski? I dont know how to disconnect the wires that run through it

 

[Big Kahuna]

you dont............
work on it in the ski.

 

[Big Kahuna]

wait, what year ski is this???

 

[IceRocket1286]

nvm I got it. Its an 04, yes I can jump the sensor wires or plug in the FPP plug, but I got the advance plate for free and chose to do it this way.

 

[Scorn800]

Your going to have to grind the locating bosses off the pick up.
Remove the flywheel cover assembly from the boat, There 2 bolts on the electrical box, take them out and unplug the connection (thats where the wires go.)

 

[IceRocket1286]

thanks scorn, but the flywheel cover is already gettin put back on, I got it! yayy thanks for the help guys

 

[Big Kahuna]

when we got our 04's, at the time, Nobody could possitively gurantee that the jumper would work, so, we had the plates put on....... (only thing that I ever had a dealer install, but a friend who brought them too us, was the same guy that prepped the ski's, so had him do them...) otherwise, I would have used the jumper, but I think we are getting a little more advance with the PJS Plates.