Hi,
I use a kommanderind head (the same as the JSU), and I would like to know the torque specs for the girdle kit.
I secure the 8mm head nuts to 22ft.lbf (30Nm). Shall I secure the 8mm girdle screw to the same torque ?
I didn't write a mistake, on these heads, girdle screws are 8mm, not 10.
That's because the JSU system need to drill the cylinder to allow girdle installation.
Thanks,
Seb
I use a kommanderind head (the same as the JSU), and I would like to know the torque specs for the girdle kit.
I secure the 8mm head nuts to 22ft.lbf (30Nm). Shall I secure the 8mm girdle screw to the same torque ?
I didn't write a mistake, on these heads, girdle screws are 8mm, not 10.
That's because the JSU system need to drill the cylinder to allow girdle installation.
Thanks,
Seb