SXR sxr cooling question

[bcemkara84]

quick question. i got a sxr hull that i am almost done building but i have some cooling questions. the old owner had a factory pipe on it and was running the stock bilge dump thru hull line for dual cooling. he pulled the line out and ran a 3/8 copper line through. the pump is only tapped on one side tho... now i am running a stock pipe and what do i do with this copper line?

 

[vitalikol]

Cup it if you don't use it

 

[bcemkara84]

so i dont need it?

 

[bcemkara84]

maybe i am not explaining this right. i have one line coming off the pump via 90 brass.. thats my main 3/8" cooling line. i also have the 1/2" stock bilge dump... but i have a third line that goes to the stock pipe... what does this line do? do i just leave it open at the end my the pump?

 

[rollin5150]

You will have two overboard fittings when running a stock setup. One a unmodified SXR, one dumps out the front of the ski and the other dumps to the pump area. Use that extra line for your overboard or cap is and run another overboard in the front.