Hi, I need to rebuild my ported cases, because one of the screw broke the epoxy film in the upper case. I removed the whole aluminium expoxy on both intakes, but now I would like to know what is the best way to fill them again.
I saw that the product to use is DEVCON 10710.
But my question concerns the way to fill in the cases.
I build two plates to replace reeds.
How shall I place the case ? Reed plan locked vertically or shall I put the upper case on an horizontal plan ?
IS there a specific height to respect ?
I use Boyesen intake without spacer, and the goal is to get great low end
Her is a pic of the old work :
If you have pictures of the work you have already done, that would help me.
Thank you,
Seb
I saw that the product to use is DEVCON 10710.
But my question concerns the way to fill in the cases.
I build two plates to replace reeds.
How shall I place the case ? Reed plan locked vertically or shall I put the upper case on an horizontal plan ?
IS there a specific height to respect ?
I use Boyesen intake without spacer, and the goal is to get great low end
Her is a pic of the old work :
If you have pictures of the work you have already done, that would help me.
Thank you,
Seb
Last edited: