SXR bodywork

[AIRICCC]

I've searched this topic and not found the information I'm looking for...
I sanded my SXR too deep and it revealed several pinholes in the gelcoat...
I have a couple gallons of West System Epoxy resin and a few different fillers, phenolic microballoons, Fairing compound, and Cab-o-Sil...
I know Cabosil is better for glueing and I should probably use the balloons or fairing compound. My main concern is the technique I should use to fill these pinholes... should I make a very thin filler and spread it over the surface or will that not fill these holes? Any help appreciated, it looks terrible.

 

[TITAN]

Pics would help

 

[IceRocket1286]

For pinholes just use a body filler like evercoat. Spread it on thin and sand it smooth. If you spread it on thin you can usually sand it with 120 or higher and then get more fine with your grit, leaving it ready for paint.

 

[TITAN]

West systems has these instructional videos out there on how to fix stuff. Just check them out. Kinda cheezy but real good.

http://www.youtube.com/watch?v=b0XBPbXKz8s

http://www.youtube.com/watch?v=OoU4DzYor3g&feature=related