Super Jet Super jet something wrong

[c310]

I just built 760 and I went for second ride yesterday. But I found that when I'm on flat water the ski working well without problems. I reached to the surfs side and when I hit the first wave the ski start to not respond to the throttle and make noise braaaaab braaaaab after 5 seconds the ski resumed as normal and when I'm hitting the waves I'm getting same week throttle respond. Any suggestion or did any of you have same issue? It's an electrical like blugs caps?

 

[shannon cone]

i had same problem last weekend. found out that my bildge pump had a hole in the line and was squirting water into the carb. what are the odds of that. the only way i found out was when i brought it home i fill the hull up with fresh water and kick the bildge on and thats when i found it. good luck/ keep us posted

 

[c310]

i had same problem last weekend. found out that my bildge pump had a hole in the line and was squirting water into the carb. what are the odds of that. the only way i found out was when i brought it home i fill the hull up with fresh water and kick the bildge on and thats when i found it. good luck/ keep us posted

I opened the hood and i run the ski for 5 minutes the bildge working well with the correct rotation. I believe that I have wire or fule line moving from the place when I'm hitting the waves. Please help

 

[teddy]

i had a similar problem awile back. it felt like everytime i landed off a wave it would run on one cyl and i would have to work the throttle so it didnt bog out on me. i bought new plug boots and cut a about a 1/4'' off the wires and it fixed my problem...

 

[c310]

i had a similar problem awile back. it felt like everytime i landed off a wave it would run on one cyl and i would have to work the throttle so it didnt bog out on me. i bought new plug boots and cut a about a 1/4'' off the wires and it fixed my problem...

yes that's what happened it's seem that the ski run in one cyl. I will change new plug boots and I'll try it today hope it will fix my problem. But why you cut the wire about 1/4 could you explain me?

 

[Shadow7874]

If the wires are corroded then cutting them back normally takes care of that problem. Usually it will corrode at the ends since they are more likely to see water

 

[c310]

If the wires are corroded then cutting them back normally takes care of that problem. Usually it will corrode at the ends since they are more likely to see water

Thanks for the help I just done what you said to me I tried the ski today every thing was good but the problem happen to me twice nor like befor do you think I need to change whole wire?