This has probably been discussed before, but i seem to have some trouble with my Start / Stop / Kill switch on my B1.
Last Season my the kill switch would stop working (the engine would not stop when the lanyard was pulled) i then pulled it apart, and stretched the spring a little bit so that it would push the kill switch a little better. Also cleaned the whole thing with contact cleaner. That seemed to do the trick.
However yesterday, i put the blaster in the water for the first time of this season, and the trouble is now back again.
Any idea for a permanent fix of this problem? I think the trouble is with the little plastic thingy that pushes down on the rubber button inside the switch. It seems to get stuck and not push down properly.
Last Season my the kill switch would stop working (the engine would not stop when the lanyard was pulled) i then pulled it apart, and stretched the spring a little bit so that it would push the kill switch a little better. Also cleaned the whole thing with contact cleaner. That seemed to do the trick.
However yesterday, i put the blaster in the water for the first time of this season, and the trouble is now back again.
Any idea for a permanent fix of this problem? I think the trouble is with the little plastic thingy that pushes down on the rubber button inside the switch. It seems to get stuck and not push down properly.