- Location
- bhc,az
I want to do this right. All advice and ideas are appreciated. For this project I want to start by perfecting the inside of the hull,etc.I want to do a real clean install. I have a big bore motor going in. I also want to make the outside as nice as possible. I want to sanitize the sponsor they look hack.,new hood seal, outside trim anything to make it nice because it will get a lot of use.
I'm not in a rush and I have the motor sitting here ready to go. So I'm starting by taking out the old motor and getting ready to power wash the inside of the hull.all ideas are appreciated. The drivetrain is already done.
