Super Jet Sleeve sitting above deck

[Sablabra]

Hi.

My sleeves are sitting above the cylinder deck 0.05mm on the first and 0.15mm on the other. I have a O-ring head.

Is this a problem? 61x cylinder.

 

[QJS]

Very unusual for them to be proud, and yes it could be a problem. I suggest you heat the cylinder in an oven to allow the sleeves to drop down then use a press on the sleeve only to make sure its fully seated.
Chris.

 

[Sablabra]

I got the top of the sleeves decked, and now both are just sitting 0.05mm above, tried to press them further down with no result.