I've been looking at the WCF top decks and must say I'm pretty impressed. However, I wouldn't be a very good consumer if I didn't ask who else makes a top deck. I've heard WDK "used to" make one and XFT "used to" make one. So basically the only company I've seen that makes a top deck is WCF. Is that right?
SJ Top decks?
- Thread starter Waternut
- Start date
Waterdawg Kustomz
RIP NATION
- Location
- Pac NW
We have three choices. First the roundnose SJ replica, X-Jet, and REV. They all fit perfect on the SJ bottom. We also have the front piece you will need if you are doing a square conversion. The lay up can be one of many choices ranging from wet lay up (open mold), wet lay up (closed mold vacuum bagging), or prepreg. All lay ups can be 100% fiberglass, combination glass and carbon, or all carbon. Same goes for prepreg, but has to be all glass or all carbon, no hybrid lay ups. Pricing ranges from $800 to $2000 depending on which one you choose. You can pm if you need more info.
Jeff
- Location
- vallejo, ca
so who is it?
- Location
- vallejo, ca
anyone have a pic of the x-jet?
brett
-------------
- Location
- Ventura,ca
no necesario
RiverRat
.......
- Location
- Louisville, Ky
here ya go.
Attachments
A few things to consider too, since I just went through this process myself:
weight - a stock topdeck is around 35lbs based on my weights, XFT's seem to be the lightest (freestylegeek's was 12 lbs), Watercraft Factory's slightly above that, Waterdawg's above that, but it also depends on the layup you want.
shipping - XFT's is about double that of WCF/WDK to here in the US, for obvious reasons.
weight - a stock topdeck is around 35lbs based on my weights, XFT's seem to be the lightest (freestylegeek's was 12 lbs), Watercraft Factory's slightly above that, Waterdawg's above that, but it also depends on the layup you want.
shipping - XFT's is about double that of WCF/WDK to here in the US, for obvious reasons.
snowxr
V watch your daughters V
- Location
- Waterford, MI
Last edited: