SJ pole on 750

[yamanube]

Starting to look into this for a side project, can I just use the RRP bushings for kawasaki applications to install a round nose SJ pole on a 750sx?
Anybody have pictures of how they attached the steering up top?

 

[Rushford_Ripper]

People do it with SXR's, I don't see why you couldn't with a 750. Maybe research how its done with sxr's to give a starting point?

 

[Vumad]

@Scraggly makes custom bushings if it becomes necessary

 

[TheBuzzard]

since kawis turn from the left side up top, you have to use the squarenose type cable clamp at the top. blowsion sells them. I've put many UMI poles on my SXRs. center the bars and the nozzle with the cable clamp on the cable. that's where you drill holes and mount it. the kawi pole bushings are too narrow. I made spacers with delrun so I didn't have to buy anything.

 

[GabeH]

Custom derlin bushings as well. Bolt up stock Kawi steering cable bracket where needed, check for any binding or interference, and enjoy! Trial and error. I only run Superjet-type poles on my Kawis.

Sent from my iPhone using Tapatalk

 

[yamanube]

Does an RRP pole not use the same bushings as a superjet? If the answer is yes, can't I just get these RRP-Kawi bushings?

https://www.blowsion.com/rrp-billet-pole-bushings

 

[GabeH]

The Blowsion ones I’ve used in the past were a little loose. When you have them “made to order” on a lathe, they are nice and snug. That’s just been my experience though...


Sent from my iPhone using Tapatalk