SJ nose² to roundnose bracket-update

[surfgy45]

a little updateness! started off with some measurements then followed up with a ProE program design. the measurements taken by a few board members are dead on! Mouthfulloflake, waveblaster, romack, few others i forget...

was able to fit it up to the new pole today, and it works niiiiice :headbang:

could use a little more clearance when the pole is extended forward more. not vertical but almost to that point...it touches. waiting for the pole limit rope

 

[romack991]

nice!, pretty pole btw too!

 

[hangtime]

What did you make that out of ??

 

[surfgy45]

it'll be machined down from a block of 6061 or something.

haha since when do we have this?? >>>:cheer:

 

[yamaslut]

it'll be machined down from a block of 6061 or something.

haha since when do we have this?? >>>:cheer:

she's awesome

:cheer: :cheer: :cheer:

 

[surfgy45]

hey i need some opinions before i finalize it. the center breather tube on the pole is 2 inches roughly. should i make the breather hole on the bracket 2" too and have the tube have some slack and be able to move slightly?

or make the breather hole on the bracket a little smaller to where i have to force it in and then the tube doesn't move at all once positioned?

just curious about water coming in...seal the extra space with a silicon or tight fit

 

[surfgy45]

oh and the tube it self is pretty stiff. it flexes but not that much...

how do the aftermarket breather tubes fit??

 

[crammit442]

oh and the tube it self is pretty stiff. it flexes but not that much...

how do the aftermarket breather tubes fit??

Make the hole so that you almost have to thread it through. It's fairly stiff but flexes plenty for what it needs to do. Working VERY well on mine.

Charles