Super Jet RIVA TYPE 4 INSTALL (HELP)

[superjetguy]

I just bought a riva type 4 pipe for my sj and I'm confused with all the hoses and stock pisser. I have a elbow on the bottom of the exhaust manifold and all the rest of the ports on the exhaust manifold are caped.

Basically I need to know where to run each hoses from each number I put on the photos while eliminating stock pissers if possible. I have 3 pissers out the side that I'd like to use. Any suggestions ??

 

[just joe]

Supply line goes from pump water supply to elbow on manifold (3). You won't use (2) or (1) unless you want to run dual cooling to pipe and water injection.

If you want to run dual cooling into manifold, then run second pump supply line into (2). Run water injection into (1).

Run line from head to (4).
(5) connects to (7) with a flow control. You also want to run a 195 main jet inside the stinger inlet (7). It will screw in.

(6) goes to a pisser.

 

[superjetguy]

Thanks a ton man

 

[Big Kahuna]

Looks like the High Rev Chamber. Those are harder to find.

 

[Harbor]

If your running dual cooling you may want to double check position #2 it may be a thru hole to exhaust stream and not to the water jacket. On my previous ski my water injection spray bar screwed into a boss in that position and my water injection boss was off center like yours is in position #2

 

[just joe]

If your running dual cooling you may want to double check position #2 it may be a thru hole to exhaust stream and not to the water jacket. On my previous ski my water injection spray bar screwed into a boss in that position and my water injection boss was off center like yours is in position #2

Yes, good catch, I agree. 1 and 3 should be cooling water, 2 would be water injection. I crossed them in my post.