DC SUPERJET
Half a roll
- Location
- Lake Michigan
does anyone know where to start for jetting a riva red pipe? It's going on a stock 2000 sj.
riva red pipe jetting
- Thread starter DC SUPERJET
- Start date
OCD Solutions
Original, Clean and Dependable Solutions
- Location
- Rentz, GA
I just pulled one off my ski. It was running great and pulled hard. I have a different prop too but jetting should be close enough. These are the same specs that Riva gave out with the pipe install and they were bang on for a stock boat. I turned the LSS in slightly just to crisp up the bottom end.
stock Dual 38's with choke plates intact and Riva Flame arrestors
Main 130
Pilot 70
N/S 1.5
Spring 95
LSS 7/8
HSS 1 1/4
Hope this helps
stock Dual 38's with choke plates intact and Riva Flame arrestors
Main 130
Pilot 70
N/S 1.5
Spring 95
LSS 7/8
HSS 1 1/4
Hope this helps
DC SUPERJET
Half a roll
- Location
- Lake Michigan
that helps a lot, thanks
OCD Solutions
Original, Clean and Dependable Solutions
- Location
- Rentz, GA
How did those specs work out?