R&D Reed stuffers, any bueno?

[surfgy45]

kind of forgot i had them in there until i pulled my set up off yesterday:sneaky:

its a freestyle boat, do i need stuffers?

what do they do?

 

[waxhead]

in my op
they kill the midrange of nicely and lose you 100rpm up top
I have not found a gain with them but i certainly found a loss

 

[Mile9c1]

They can work for freestyle if you set them up right.

 

[surfgy45]

what do you mean set them up right? for dual 44s, just set up the correct jets, pop off, and tune it correctly sort of thing?

 

[Mile9c1]

what do you mean set them up right?

That I don't know :banghead: But I know someone who runs them in a Team Scream engine and he says it's the quickest hitting engine he's ever ridden. It's not a race motor, that's why I said "for freestyle".

 

[waxhead]

i bet if he takes them out then it will hit even harder
or if they fit v-force it will hit harder again

 

[surfgy45]

i was thinking if i take them out id get a larger air volume intake...i dont know, im no where near motor savvy

 

[Mile9c1]

i bet if he takes them out then it will hit even harder
or if they fit v-force it will hit harder again

He doesn't say it hits hard, just that it hits EARLY. It signs off early too. But it's a freestyle engine, so it gets the job done.

 

[waxhead]

its all good different setups for different people
i have found it kills your grunt if you run them
and thats when it hits or how hard it hits

 

[surfgy45]

well heres my new set up, wasn't sure if i should leave them in there while i do the build. i dont know the technical side of things...

62t/61x, RAD, msd enhancer, dual 44s, carbon tech reeds, ada girdled 180psi, fp type 4, skat swirl, ww cone, 83mm pump

 

[Mile9c1]

I'd sell the stuffers, but fill in the fingers on the cases. Just my opinion.

 

[waxhead]

i have never tried filled in fingers
they say that works well