quick sizing question for those with bell ballistic helmets

CarFanatic

Fiberglassing Newb
Location
Cincinnati, OH
I Want to order one, since everyone says there more comfy then the prorider. MY head is about 57cm.. I'm not sure if thats 100% acurate. In an MX helmet I wear a small. My question is what size should I go with? I hear they get a lil loose when they get wet, I"m leaning towards small.. but not sure since I'm kinda in the middle.
 
I'm 57 cm and had to go with the large. First I had a medium but it hurt like hell, so I sent it back. The large is comfortable and does not come off when I do subs and stuff. I wear a medium streetbike helmet, which is why I went with the medium to begin with.
 

Proformance1

Liquid Insanity
Site Supporter
Vendor Account
Location
New York Crew
22 1/2" and i wear a medium and it's a little too big, but frostys medium fits me perfectly. There may be some differences in manufacturing.
 

Crab

thanks darin...noswad!
Location
Seattle
The large was just falling off my face, you want it snug as it will get a little looser when wet.
 

Mike W

Infidel
Location
North Florida
Measure the circumference of your head and divide by 3.14. That will give you your hat size then you can cross reference it with the helmet sizing.
FWIW, my hat size is a 7 1/4 and I wear a medium helmet.
 
Last edited:

CarFanatic

Fiberglassing Newb
Location
Cincinnati, OH
There was nothing in the directions that said what they where and how or where to put them. I went through the entire book. so they supposed to velcro in somehow??
 
I put all 4 of them in my helmet. One on the top, one in the back, and one on each side. They stick to the velcro hooks that are already taped to the inside of the helmet. One side of the foam strip is "hairier" than the other, so thats the side you stick to the hooks.

The helmet will loosen up when it gets wet. So wait till you give it a try before you make any adjustments.

I bet you're glad you didn't go with the small :eek:uch:
 
Under the liner (inside the helmet) there should be small squares of velcro taped to the hard part of the helmet.
 
Top Bottom