Flat Brapp
h2o
- Location
- Jacksonville florida
From idle to half throttle if you stay at one speed for more than 5 seconds the ski begins to load up. Should i lean it up on the main jet? Pop off maybe?
Quick question.....
- Thread starter Flat Brapp
- Start date
Flat Brapp
h2o
- Location
- Jacksonville florida
come on...........
stanton
High on jetskis.
- Location
- atascadero,ca
turn in the low speed screw(s) one 1/8th turn.
continue until it goes away.
continue until it goes away.
Flat Brapp
h2o
- Location
- Jacksonville florida
Thanks guys.
Flat Brapp
h2o
- Location
- Jacksonville florida
Well, i have been messing with them and the only way to eliminate the loading up was to lean the high speed, it didn't go away until i was 1/8 out on the high speed. WTF. I have 135 mains on a motor with a limited FP and a protec head with stock carbs and F/A. Im lost.
Last edited:
- Location
- Winnipeg Manitoba
I would say raise the pop off. Is it a Superjet with stock 38mm carbs?
Flat Brapp
h2o
- Location
- Jacksonville florida
Its got 115g springs in there now. Stock carbs, stock reeds and cages, stock air box with screens.
- Location
- Winnipeg Manitoba
I would check the pop off with a gage to make sure it's what you want. The specs from Factory pipe usually work well for a Superjet.