Pump Seal

[pioui1]

Can somebody Please tell how to removed these DAM Seal ,I am going NUTS,

thank you

 

[Tyler Zane]

First you will need to remove the driveshaft. It presses out of the back side or the stator section once the pump cone is removed. Once the shaft is out you can pry the seals out of the front and press the other bearing out the back if it staying in the stator.

 

[pioui1]

thank you, the shaft is out ,I just have the stator the front bearing and the seal,but seal are very difficult to removed

 

[Tyler Zane]

Use something to pry upward going in and under the center of the seal. I use a foot long flat head that i cupped the end of just for pulling seal. Just be careful not to go to far under the seal as you will gouge the outer metal area.

You can buy a seal puller at any local auto store too.

 

[pioui1]

Thank you I have the bearing in the way, if I used a dremel to cut some of it