Pump Barings how big press do i need ??

[orangefinger]

I want to replace my pump barings how many tons of a press do you need ?

 

[WaveDemon]

I use a hammer.

 

[orangefinger]

wow, pls explain how u go about...getting the first one out ?

 

[Wave Chaser]

It takes very little pressure any press will do. They will also tap in with a mallet but doing it that way can damage the bearings. I have done it both ways. Never had any problems come up with ones I tapped in.

 

[orangefinger]

I have done numerous ones when i still was a car mechanic but never had a driveshaft sticken out either...

taping in no problem just want to make sure I do right taking old ones out..

 

[Talsivar]

take the pump apart set it up on two pieces of wood, so the pump is raised with room for the shaft to move. put a block of wood on the shaft,then give it a whack with a hammer or sledge usually pops out in one hit.