Pro-tec Mach 2 cooling question???

[tipafew]

Anyone know how the cooling lines are supposed to be run on the mach 2 pipe? I have a friend that I was helping last night with a install.

Chad

 

[monsterSJ]

call me we putt one on de witts sj and we did it the way pro tech told us too

 

[EvanB85]

Not sure how similar they are, but here are the instructions for the Mach 1.

 

[tipafew]

Yeah, The instructions I found on the Pro Tec site didn't match those. It shows one of the lines from the pump being split through a selonoid and then into the pipe.....I am assuming this is only if water injection is used. Right where the manifold bolts to the head pipe there is a threaded plug.....I am guessing that is where the water inlet would be after the selenoid?????

Does the outlet off the head go right out the bypass?? The instructions don't mention that at all.

 

[tipafew]

I am trying to figure out why there is a fitting on the top and on the bottom of the manifold??? Do they both feed the motor?