oiling crank before install

[accbr]

Probably a dumb question. How much oil do you need to put in the crank case oil holes? How much on the bearings on the end before you install the oil seals? Just lightly coat or fill it up? 30W, 10W30, 10W40 etc...? :biggrin:

 

[Water Worx]

Put a little (squirt) on all bearings including rod bearings.:smile:

 

[robertg]

I use two cycle oil, too much is not going to hurt unless you hydrolock it. I use grease on th seals also.

 

[accbr]

Thanks. Now back to the garage.