Hey all, I'm having a running issue with my 61x bottom, 62t hpe ported cyl, new oem crank, Westcoast head, b pipe, limited, lightened flywheel, msd enhancer. There's no low end snap. The chamber recently overheated from running in very warm water. Bottom and middle screws are seized, so I don't know their settings, top open 1/4. I added a 2.0 n/s as a restrictor on the overboard pisser, test run. Not overheating, but no low end and the t from head pipe to stinger is now not pissing water. Any thoughts? I'm confused on this one. Thanks!
No water going overboard?
- Thread starter truth609
- Start date
Rushford_Ripper
Site Supporter
- Location
- New York
I agree with the clog or maybe a bad head gasket?
Big Kahuna
Administrator
- Location
- Tuscaloosa, AL
back flush everything, I just went though this after going to Hugo a while back, got sand in the headpipe, had water flowing but none going into the small injection holes.
Thanks for the tips! The head gasket is a new oem, I pulled the line going to the headpipe and blew in it and it wasn't plugged, i was able to blow through it. Could it still be plugged and do this? What's the best way to back flush? Unhook the stinger line and blow air into the line? Thanks guys!
Big Kahuna
Administrator
- Location
- Tuscaloosa, AL
You need to check the line from the pump to the bulkhead, the intake tube thru hull, bulkhead to exhaust manifold.
Big Kahuna
Administrator
- Location
- Tuscaloosa, AL
If your not getting water out of your pissers, then you have a blockage. also, pull the head pipe and hook it up to water, pull the top screw adjuster out. be sure the inlet hole is not clogged. Just had this happen to me a few weeks back.