No start/crank nothing.

[Yamadoo54]

I have a 14 rickter XFR and just put a new stator in it. Now it has no crank or start when pushing start button. Could this be the coil is bad or the start stop switch?

 

[Jcary85]

No crank at all will not be coil. Start by checking battery is charged and all battery cables are connected properly. Next, disconnect your start wires at the Ebox and jump the connector on the Ebox. If it cranks, it’s a problem in your start/stop switch. If that doesn’t work, put a voltmeter on the wire on the starter and press the start button. If you get voltage, problem is likely the starter. If you don’t get voltage, it’s likely the solenoid in the Ebox. (Assuming stock type ignition)

 

[Yamadoo54]

No crank at all will not be coil. Start by checking battery is charged and all battery cables are connected properly. Next, disconnect your start wires at the Ebox and jump the connector on the Ebox. If it cranks, it’s a problem in your start/stop switch. If that doesn’t work, put a voltmeter on the wire on the starter and press the start button. If you get voltage, problem is likely the starter. If you don’t get voltage, it’s likely the solenoid in the Ebox. (Assuming stock type ignition)

Thank you for the reply! I did do all of that. I’m going to try a new solenoid today and a new start stop switch

 

[Yami-Rider]

Stock ebox gets its ground from a wire going to the stator, make sure you have a good ground at ebox(use a multimeter)