No low end with my set up??

[SuperjetSteve]

Well when i rode my sj It felt like no low end power.It seemed like my stock kawi had more low end.Im just trying to figure out how i can get low end with my set up

Type 4
Stock head (ada wont hold compression)
single 44
carbon reeds
13/17 concord (forgot pitch)
ww cone

 

[tor*p*do]

6m6?
701?

 

[SuperjetSteve]

6m6 cases but i got 701 bored over 1mm and my exhaust ports are opened.

 

[Mile9c1]

Well your Kawi is a 750... but you probably need to adjust your jetting a bit.

 

[Kennay]

don't forget to post up a pic or two of your water routing

and why don't you buy some new o-rings so you can have some decent compression

 

[DaUpJetSkier]

i got the same setup, well did have an ada now but im in a similar boat, ya I got bottom end but i have a feeling it should be more.

 

[Crab]

Well when i rode my sj It felt like no low end power.It seemed like my stock kawi had more low end.Im just trying to figure out how i can get low end with my set up

Type 4
Stock head (ada wont hold compression) stinger
single 44 single screen in F/A
carbon reeds stock reeds
13/17 concord (forgot pitch)repitch to Impros freeride spec.
ww cone

Check for restricted waterbox and presence of jet in stinger.

 

[NW Lover]

I had the same problem... I had ran my h2o lines wrong... So I put equal length lines coming out of the head and ran them correct. After that the ski had alot more BRAP!!!

 

[SuperjetSteve]

Check for restricted waterbox and presence of jet in stinger.

There is a jet in there to restrict it.

 

[crashski]

Since you ran it have you looked to see if your plugs are wet? With my ADA head I had a slight leak into my front cylinder it acted the same way. Also do you have to out lets off your stock head? how is your water routing set up?