New Turnplate, now steering is off...?

[MattyBoom]

Well i picked up a billet turnplate system off ebay, i slapped it on this past weekend and im having problems with the steering...

My problem is, it will turn the nozzle completely one way, and it stops on the stop, and then in the other direction it only makes it about half way.

I did some research, seems if the cable was put in backwards this usually happens, but as far as i know the cable hasnt been changed or modified, and it worked with my stock setup...

This is the system i picked up....

http://cgi.ebay.com/ebaymotors/ws/e...witem=&sspagename=STRK:MEWAX:IT#ht_500wt_1182

Let me know if you have any insight.

I also tried to see if i could adjust the cables but it seems that its pretty much tapped out.

 

[tipafew]

You need to adjust that cable. Both ends can be threaded farther on or off as needed.

 

[MattyBoom]

I'll mess around with the adjustments a little more, just didnt seem like it could be adjusted that much, like the amount i needed was outside the range of adjustment.

 

[swannysxr]

double check that groove in cable housing is in bracket correctly, if still stock pole? i have seen inserts inside stock poles crack.

 

[MattyBoom]

I have an AC alum handpole, the cable bracket is on the ac handpole (its about midway up) should i check somewhere else?

 

[nokfir]

since that turnplate rob give you more throw (wider and pulls the cable further) it offcentered your cable. losen both the ball end joints near the turnplate and the pump and play around with them (screwing them in or out) until u get it centered againd.

 

[MattyBoom]

Will do, i'll mess around with it a little more, i got aggrivated last time i was working on it cause my batt was dead and couldnt go riding.