need some advice for my set up
- Thread starter fallout
- Start date
RyanO
X
- Location
- Gold Coast, Australia
175-180 with good pump ga.
usually anything above that and you will want to be running race gas.
usually anything above that and you will want to be running race gas.
those are kinda the two extremes from race gas to cheap regular,
hi to lo performance,
I would go 175 psi and run super from the pump
SUPERTUNE
Race Gas Rules
- Location
- Clearwater Fl.
Not enough info...Would need a lot more specifics on the set-up, How many degree's did the timing light show when you checked it with the enhancer installed? What is the squish ratio and squish clearances to the piston? Is your nozzle bored? You should do a port map and check your port degree timings, blowdown time and a measured compression ratio check to make a decision on how high you could go...
re
this is what i know
84.5 bore
5mm rad crank
ada billet cylinder and head
r&d intake w/novi carbs 49's or 50's
msd enhancher
coffman sizzler
reeds but dont know brand
stock flywheel
the only thing i did was a compresion test and dont even know if i did that
right but the domes iam running came in @ 150psi and the domes part# indecate that they are 41cc but then where scratched out and 51 cc engraved in them.
sounds like i need to find someone in oregon who knows how to do what you just said.
wow you just blew me away!!!!! i dont know how to check any of that.
this is what i know
84.5 bore
5mm rad crank
ada billet cylinder and head
r&d intake w/novi carbs 49's or 50's
msd enhancher
coffman sizzler
reeds but dont know brand
stock flywheel
the only thing i did was a compresion test and dont even know if i did that
right but the domes iam running came in @ 150psi and the domes part# indecate that they are 41cc but then where scratched out and 51 cc engraved in them.
sounds like i need to find someone in oregon who knows how to do what you just said.
Big Kahuna
Administrator
- Location
- Tuscaloosa, AL
contact Randy at Watcon