My 61x cylinder is toast. Bored twice. Who can sell me a freestyle ported 61x? I keep snagging the upper ring on mag piston. It was race ported. I want to work with a good engine builder. What are my options for getting back on the water asap. Does sbt sell 61x stock cylinders? I would hate to have it bored over again if it were even possible. I don't like the porting I have been running.
Blaster need a fresh 61x
- Thread starter catpower
- Start date
- Location
- UTAH
#jetmaniac
Mike W
Infidel
- Location
- North Florida
^^^
Quinc
Buy a Superjet
- Location
- California
Check out the for sale section. There is a stock port 61x for 150$
- Location
- UTAH
Send him a PM. Tell him what you want and he will ship it to you in 2 days. http://www.x-h2o.com/index.php?thre...new-used-yamaha-and-custom-build-parts.85372/
- Location
- springfield il
jetmaniac=best
- Location
- South Florida
I have a stock 61x cylinder that i think is bored over 1mm, but could use a bore for $90 shipped. I can send it straight to jetmaniac.
BruceSki
Formerly Motoman25
- Location
- Long Island
I have a 61x cylinder. Currently .50 over. Customer overheated and had four corner seizure. Pistons look bad but cylinder looks like you could get away with just a hone. But I'm no machinist. Just tried the fingernail scratch test on the marks in the sleeve. Stock porting.
150 shipped.
150 shipped.
Thanks but I've purchased a couple since. In fact one of them I got out of a VXR in Michigan salvage yard. ( Mickeys ) 61x and pistons. I was surprised I got 145 psi compression out of each hole. I ran it 3-4 hours last weekend no problems. I'm leaning toward 771 BB for this winters project.