MSD Total Loss Question

[rwilliamtaylor]

I'm trying to set up a Multi Channel MSD Total Loss and I've run into a snag. The ski starts and idles fine and there is a massive spark from the ignition. As soon as I apply throttle the motor sounds like it's hitting a rev limit. I'm not using the holeshot feature and the blue wire is just tie wrapped to the mounting plate but not connected to anything. Do I need to connect it to anything? The holeshot switches are all off (3000 RPM) which makes me think this might be the issue.

 

[augustaf]

The blue wire is for an optional holeshot switch, make sure it does not ground out on your plate.- not needed.
If dipswitch settings are in doubt- go to MSD website and look at the switch settings when new.