Let it drain

[aqua]

well.....i went to lowes yesterday and did some brainstorming. in the toilet section they have some plastic bushings that have a flange on one side. these are prethreaded on the inside and are even recessed so that when i screw a small bolt into them they will sit flush. I plan on using an oring on the bolts too so they should seal good. when i want to drain i just grab an allen wrench and back the stainless allen bolt out. i think these will fit perfectly below the exhaust output also. only problems is when do i want to take a week off from riding for my 3m 5200 to setup. i might have to go with 4200 for this one. :biggthumpup:

 

[Mark44]

p

well.....i went to lowes yesterday and did some brainstorming. in the toilet section they have some plastic bushings that have a flange on one side. these are prethreaded on the inside and are even recessed so that when i screw a small bolt into them they will sit flush. I plan on using an oring on the bolts too so they should seal good. when i want to drain i just grab an allen wrench and back the stainless allen bolt out. i think these will fit perfectly below the exhaust output also. only problems is when do i want to take a week off from riding for my 3m 5200 to setup. i might have to go with 4200 for this one. :biggthumpup:

Use epoxy resin and filler. No wait time.

Mark44

 

[onesojourner]

you could do the fast cure 5200. I just picked some up at work.

 

[sjetrider]

Out of curiosity, how often do you drain this much or any water from these drains?????? Is this the 1st time?

 

[Mark44]

After a month or so of riding I drain maybe a cup of water out. When I refoamed this ski I sealed every penetration and bond line on the inside and out but after about a year I started getting a little water from the hull.


But this was the firt time for a gallon because of the worn out foot holds.

Mark44