- Location
- Central Florida
i can't seem to get the exhaust nozzle off is it attached to the exhaust pipe?
is the exhaust tube attached to the nozzle?
- Thread starter superwetbrett
- Start date
Mark44
Katie's Boss
- Location
- 100% one place
You may need to take a block of wood and hammer from the inside of the hull to tap it out. If you refoam wrap it in plastic wrap reinstall pour foam let it set up then take the tube out and plastic wrap off and reinstall. Makes it come right out next time.
Mark44
Mark44
- Location
- Central Florida
damn so i broke the seal around the nozzle thinking it wasn't attached.. so i guess i should tap the exhaust tube out a little and then seal it back up?
- Location
- Houston/Galveston
im not sure why you would think the exhaust tube was attached to the nozzle.
If all you want to do is remove the Stainless Exhaust tube that goes through your tray, do as Mark said. Tap it out with a piece of wood.
Also are you calling the exit flange "The Nozzle"? The one with the three rivets?
If all you want to do is remove the Stainless Exhaust tube that goes through your tray, do as Mark said. Tap it out with a piece of wood.
Also are you calling the exit flange "The Nozzle"? The one with the three rivets?
What seal?!?!?!? Take a picture......
- Location
- Central Florida
the ski is getting gel coated on the bottom and i was trying to take everything off
- Location
- Central Florida
the exhaust is sealed so that water doesn't get into the tray
- Location
- Central Florida
yes i am calling the exit flange "The Nozzle" thats what they're calling it on blowsion's website
I wouldn't call being held in place by rivets and MAYBE a film of silicone a seal......
- Location
- Central Florida
i don't really know what else to call it.. hope you know what i am talking about..
Last edited:
- Location
- Houston/Galveston
- Location
- Houston/Galveston
See post #3.
drill the rivets and knock the tube out with a board. Oh yea you might have to remover your exhaust and or whole motor to get a good swing at the tube.
Mine is sealed like a mofo now!!!! With rivets and damn near a whole tube of 5200