SX/SXi/SXi Pro installed factory pipe, wont idle

S

soyo102

Location
Holland, MI
so i just installed a factory pipe on my 750sx, also did a oil injection delete, and now it wont idle. I am mixing the gas 50:1. I jetted the carbs and set the low and high screws the way factory wants them. I had my hood setting behind it at one point and the water coming from the exhaust was landing on it and it left a oily residue over the whole hood after only being there for like 5 seconds of running. it seems to run fine when I give it gas.

Just to make sure, the low speed screw is the bottom one on the CDK II right?
 
S

soyo102

Location
Holland, MI
is there anyone in west michigan that can help me with this? I have been fighting with this installation for far too long now and just want it going again. I can pay you for your time if you want.
 
S

soyo102

Location
Holland, MI
Ok, so I just bought some diff jets (main: 155, 150, 145) and (low: 88, 85) I tried all differnt arrangement to no avail. But i did find an air leak and put the 155, 88 arangement back in and with the low speed adjustment screw 3 1/2 turns out it idles better but is still not idleing. Could there be another air leak or do I have to get a bigger main or low speed jet?
 
You must log in or register to reply here.
Top Bottom