i need some help

T

TheOrangeSJ

Ty
Location
Tuscumbia Alabama
I work at a fab shop and i was going through some aluminum and i found some tubeing and thought i want to build a pole for my 90 superjet so the help i need is some good pics of a pole off of a square nose i need those quick im wanting to attempt this tomorrow advise would be helpfull too.

Thanks
TheOrangeSj
 
T

TheOrangeSJ

Ty
Location
Tuscumbia Alabama
ive went over the design over and over in my head i was gonna use some 7"x 3" x 1/8" tubeing but now im thinking just break some 1/8" plate and im gonna fit and design as i go.

what is the stanerd length of an alum pole? just to get me started

Thanks
TheOrangeSJ
 
T

TheOrangeSJ

Ty
Location
Tuscumbia Alabama
tuscumbia is on the tennessee river just south of flroence where waste land lives.

i need length with and height just the part that is sheet alum not the turn plate. measure from the line where that sheet has been welded to the end on top and bottom

Thanks
TheOrangeSJ
 
T

TheOrangeSJ

Ty
Location
Tuscumbia Alabama
i didnt have much time today so all i got done is the tube and one bulkhead.
thumb_IMG_9570_%282%29.JPG
 
T

TheOrangeSJ

Ty
Location
Tuscumbia Alabama
so im setting here looking at it i dont like it im thinking that seem where i welded it will bust so i go outside and give it hell i toss it up about 10 feed and let it hit the ground sure enuff just that cracked the seem so back to the drawing board im thinking a 2 peice pole 120 pop rivets going down bothsides 1/2 inch apart ill draw up an illustration later.
It would be nice if someone had a used aluminum pole for a square nose at a good price i would buy it save me the trouble

TheOrangeSJ
 
You must log in or register to reply here.
Top Bottom