How to remove throttle switch on carb?

surfgy45

just add gas...
Location
San Diego, CA
how do i remove the piece of the throttle that the throttle cable connects to?? it has the spring on it.

im connecting dual linkage.

so far i removed the end nut.

now what?
 

keefer

T1
Location
Tennessee
If it is a Mikuni carb then removing the nut & washers should allow it to come right off. The spring will be applying tension but all should just slide off the slotted shaft end. Good luck
 

surfgy45

just add gas...
Location
San Diego, CA
got it. more encouragement was needed.

1.Remove the throttle lever, idle stop, spring, and sleeve.
2.Cut threaded shaft end to the desired length
3.Cut enough of the threaded end of the shaft to allow one eighth inch (.125”) clearance between the shaft ends: Be sure to chamber sharp edges.
4.The sleeve that was removed from the carb is actually the THRUST SPACER and must be used with coupler.
 
Top Bottom