HELP ski problem

[zwaysfs]

so last week i tried to ride my sxi pro and it started and ran fine then later in the afternoon the battery didn't have enough juice to turn over the engine no worries needed a new one any way so i threw it on the charger the 2 amp setting so i go to ride it today and now when i push the start button nothing happens all i get is a weird clicking noise in the electrical box i hit the green button and i hear click click click in the electrical box ive had problems with my coil before but i managed to wrap my wires with enough tape to keep it going ne ideas????

 

[Mark Gomez]

bad battery or faulty start stop solenoid. replace your battery a battery may read 12volts charged but will hit the floor under load.

 

[zwaysfs]

o i forgot my stop button wouldnt work last time i rode it untill i messed with the 4 prong connection to make sure it was getting good contact while i was doing it i had a little arc between 2 of the prongs but it worked after that

 

[DoGoodDrugs]

Check all your connections, test the starter by by passing the solenoid. Could be loose connection, bad starter, etc.

 

[timhoward7]

my sxi pro is doing the exact same thing. kill switch doesn't work and after getting quite a bit of water in the hull because bilge went out when you press the start button you hear a click. tried charging the battery but that wasn't the problem. did you figure out what it was. where could I order a new solenoid?

 

[st.clair.jetski]

that 4 prong connection for the start stop switch has gone on my sx and my sxi. i just cut them out and put on bullet connectors, the waterproof ones. but yeah new battery is a good place to start.

 

[ridethelip]

Your 12 volt battery has 6 cels each one contributes 2 volts.The vibration can eventually cause the failure of one of the six cels.The battery will not take a charge and the clicking noise is all you will hear after this happens.