Getting nose up on my 2014

[550headache]

already D-cut my plate. don't think it made a bit of difference. what is the next step? cutting the plate flush with the hull? I used a coffee can as the template for the d-cut. 5 inches wide and 3 inches deep. ideas? going back to back from the 2014 to the 90 is crazy.

 

[CRJ]

flush with the back of the hull will bring it up like your square.

 

[KTM434]

GP800 reduction nozzle (has 5 degrees of static trim) and cut the rideplate up to the rear bolts (past the hull) are 2 options

 

[yamanube]

Cut the plate flush with the hull and D cut, if that doesn't do it you can adjust the trim on your pump (static) up a little but it might ride like crap at speed.