FS hood and nosepiece

[jura]

Somebody know which brand this hood is?

http://cgi.benl.ebay.be/Freestyle-H...9QQihZ014QQcategoryZ39317QQrdZ1QQcmdZViewItem

Thanks.

 

[freestylegeek]

It looks like and old wammer hood.

 

[Air Gramps]

Babblefish translation...

Auctioneer a FLAT Freestyle hood with manual actions for the Yamaha superjet starting from Bj. 97 for the current form of the Roundnose. The hood is the inclusive flat Frontnose. It is only easily used, i.e. it has easy color scratches at the lower surface, at which it rests upon the seal rubber. Is however only completely easy!! It actually is flatschneu, but since it has this Macken, I auctioneer it as used. Are weigh only scarcely 5.5 kg. The original hood weighs 11 kg. The hood is auctioneered in front and the catch in the back without mounting material. The nose is for a high-grade steel Bracket. Should have you the Originalbracket still on the jet, then only the front nose must be reground. In the width, there the Originalbracket somewhat more broadly ist.(ca. 0,3mm per side). Loop goes with normal sandpaper or Dremel. If you still questions have then sends to me a Mail.....

 

[Soul Man]

Wammer doesn't have those cut-outs in the back, and the handholds are more squared off than his. Unless you mean a REAL old Wammer hood (mine is 6 years old and doesn't look like that one).

 

[Big Kahuna]

yes he did, on Rick Roys first hood they were there, before the rear scoops.

 

[THRUST]

it is an old wammer hood for sure i have some like that plus the greater yamaha sticker which 5 min from wammer.

 

[daylite67]

I'm going with Old Wammer Hood.
I can't tell if the handholds in the picture are universal, but the old wammer I have sitting at my house looks EXACTLY the same with handholds that can only be grabbed from the back and not the front.
From what I have heard the original Wammer hoods were built much stronger than the newer ones.

 

[Big Kahuna]

New hoods 180 degree handholds....

I had the second generation hood 2000-2001 or so, liner lasted 5 minutes, shattered, I did not have a pole breather but was also running a single carb, not much "sucking" pressure............... but think the hood may have been defective, not letting enough air in. either way, dont take a chance, run the pole breather in case, you should be good with that.

 

[jura]

How does it fit the superjet?

Sold for 418 Euro!!!! Thats more then 500$