FX-1 Finished Fx-1 Build

[Rev Clown]

I finally finished my FX-1 build a few weeks ago, that I started back in September. I'm glad to finally be out on the water again with a ski that rips. I couldn't be more happy with how the ski performs it's exactly what I was hoping for. Here are some pics.

Hull
-Tom 21 tubbies
-Reinforced Sides/filled bondline
-Reinforced tray
-Blowsion Digger Footholds
-144 pump swap
-Blowsion Hood straps
-Custom Limiting Rope
-Surf Seal Hood Seal

Engine & Electronics
-701 61x motor w/ mild freestyle porting
-ADA Girdled Head w/ 35cc domes
-Single SBN 44
-Carbon Reeds
-Blowsion Air Filter
-Lightened 61x Flywheel
-B pipe w/ Mod Chamber
-Setup for duel cooling
-Blowsion Primer kit
-500 GPH bilge

Pump & Steering
-144 Solas Non-setback Mag Pump
-10/16 hooker prop
-Pro tec Intake Grate
-Riva Groovy ride plate
-Custom Steering Cable extension
-Blowsion Bars
-UMI finger throttle
-Blowsion Bilge Switch

 

[special fx]

Nice.......looks clean!

 

[dankyfx1]

clean ski man! nice work

 

[Sanoman]

Should be an awesome ride! Good work

 

[aero92x]

This thing must rip nicely!

 

[Rev Clown]

Thanks guys!

 

[Dirtybird]

Very nice. Digging that blue.
Wish mine was water ready.
Its been a long road..lol

 

[550headache]

is that a true fx chamber?

 

[Rev Clown]

is that a true fx chamber?

Nope its a new Mod chamber.

 

[samsmith87]

What did you do to get the 144 pump in? Toms tunnel, or did you mod the existing tunnel to fit a 144.

 

[Rev Clown]

What did you do to get the 144 pump in? Toms tunnel, or did you mod the existing tunnel to fit a 144.

Modded the fx-1 tunnel to accept any 144mm pump.