Fiberglass Info sites

[surferdude345]

Hey has any one found any websites that have good information on laying glass. I am thinking of attempting to make some parts over break out of glass and cf. I have been looking for some info about different layups styles and plug and mold making. Or even info you might now.

I am going to see if i can layup my own hood, over christmas break i figure i have plently of time to mess with it.

 

[WDKfan]

Us composites has some info and so does fiberglast.com :biggthumpup:

 

[just joe]

I found all I needed from posts here, especially from Flash-FX. Have you seen his build posts?

 

[WaveDemon]

there is a forum set up by a member here about using composites. I'll try and find it...

 

[Speleopower]

Also, look at http://www.acp-composites.com/

I would recommend starting with something a little more simple than a hood to start with. I've done limited mold making and glass layup for radio controlled model airplanes and it's a lot harder than I thought it would be.

Here is a picture of an all composite airplane my friend and I are working on. It's not finished and there is probably 300 hours of labor and quite a few hundred dollars in it at this stage.

Good luck-Scott

 

[WaveDemon]

there is a forum set up by a member here about using composites. I'll try and find it...

I remembered....


http://learncomposites.com/

Duh.