- Location
- amarillo ,tx
I put jb weld on a couple spots that were rubbing
Super Jet Factory B pipe install. touching hull.
- Thread starter 20superjet07
- Start date
I tried to dent the pipe a little where it hit the hull. It's right on the weld and appeared to sink the weld and not the surrounding metal so I stoped. Going to stick a piece of turf in there as suggested above.
How would you keep the water box pushed to the right? Unless it's blocked with something I would think it would vibrate back to the spot of least resistance.
How would you keep the water box pushed to the right? Unless it's blocked with something I would think it would vibrate back to the spot of least resistance.
- Location
- amarillo ,tx
I put thick piece of foam between chamber and side of hull
BrightE's
Paul
- Location
- Seattle, WA
I'm going to cut the silicone elbow tube that came with my kit. It's too long and actually was kinked slightly for a good part of last season. That should help in addition to tightening the straps down as much as possible on the waterbox. I'm going to throw some hydroturf between the chamber and the hull as everyone suggested too.
- Location
- amarillo ,tx
Got me a b1 mod chamber
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
BrightE's
Paul
- Location
- Seattle, WA
I looked into that. How's the fit?
- Location
- amarillo ,tx
Idk yet havent recieved it yet, and not done with my build, its already dented to fit, after i grinded the ribs dwn a lil my limited chamber nvr hit side but was a lil to close for my likeing
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
- Location
- Great North West
B1 chamber will need to be dented for sure. fits better in 08 and up, but still need a little denting. also fuel tank needs heated and pushed in. The 2 mounts help it from vibrating all over the place. But once you get the b1 chamber set up I like the b1 fit, ease of removal and performance better.
I cut the hose to the water box 3/4" on the pipe side and it made getting the pipe back in much easier. Also put some turf under the water box and now the pipe clears the motor mount by a good 1/2" or more. It's now a PITA to get the tank in and out but the pipe fits great.